Forest#2's latest activity
-
FHead gasket blown
-
FForest#2 replied to the thread 225 won’t run without the starter engaged.Post the model number of the tractor machine and the engine model?
-
FForest#2 replied to the thread How to test voltage regulator output?.What ILengine is saying in post 9 is : It appears that the B+ post on the regulator terminal does not have a complete circuit to the B+...
-
FForest#2 replied to the thread 17.5 Briggs running rough.You need to post the model, type and code of the engine? (if you want precise answers)
-
FForest#2 replied to the thread Still trying to get the mower deck right.JimP2014: Using JB Weld and Duct tape on a Craftsman. You might be overqualified as a design engineer for Craftsman and Murray. Here...
-
FSwapping decks is usually not that easy. You won’t know until you try.
-
FForest#2 reacted to StarTech's post in the thread Briggs INTEK 22 Model 44N877-005G1 Throttle Adjustment with
Like.
The OP said it is an Intek not a Vanguard engine so that is the wrong service manual. It would be Briggs 273521 manual. That engine... -
FForest#2 replied to the thread Briggs INTEK 22 Model 44N877-005G1 Throttle Adjustment.Read next post I was editing the manual number when startech replied. Service manual for that engine is Briggs 273521. (around $30) Well...
-
FForest#2 replied to the thread Craftman 5000 Watt Generator hard Starting when Hot.So the engine was overheating? Not a good thing. Good find. Would be interesting to check the difference in temperature with and without...
-
FForest#2 reacted to SeniorCitizen's post in the thread Big trouble pulling GCV190 flywheel with Like.
With a propane torch , slowly move the flame from the outer edge area and work the way into the shaft .. Not hot but about 30° above...
-
FForest#2 replied to the thread Big trouble pulling GCV190 flywheel.Stay patient. I've seen some rough ones. I've left the puller on some overnight and go back next day and they were popped. You really...
-
FI recommend you replace the drive belt along with the stationary and idler pullies. The single speed F/R transmission in these old...
-
FForest#2 replied to the thread Adding Transmission Fluid?.All good info above. What I would do since it's a new you you free machine. and you want to work on it yourself Download a owners...
-
FForest#2 reacted to ILENGINE's post in the thread B&S model 31H7770202E1 18 HP (craftsman LT1000) with Like.
Ignition would be my first guess, but will need to confirm loss of spark after engine dies with a open gap spark tester, not a blink...
-
FForest#2 replied to the thread Craftman 5000 Watt Generator hard Starting when Hot.You say it has electronic ign and you replaced the module with a generic??? If so what specs did you set the air gap? Are you sending...