Recent content by davisonproduce

Just wanted to tell you the repair was a success!

Thank You so much for your help

Thanks for your reply, I understand the camshaft marks/edge of engine block, found this online, is the vertical alignment what you are speaking of?

So I would order the part pictured, now can the engine be timed without opening the case? Is there a timing mark on the outside somewhere, timing cam pulley seems simple enough, from what I read. Thanks in advance for help, we have a 1/4 acre garden that depends on this engine to run the tiller

Will take a look, Thanks

Well the rockers are fine, flywheel key, fine. Took the cover off and this is what I found, belt off and this 'clip' so I need to time the valves and find out about this clip, can anyone tell me how?

First, Thanks for your replies! I pulled the spark plug, I did not actually view the piston moving, but it had compression. Reckon I assumed it was moving, will have a second look. Rocker is a very good possibility. As is hitting a large rock, which I recently did, but not the last time I used...

Wasn't sure where to post this, either here or the Husqvarna section. I have a Husqvarna tiller, which has a honda engine GC 160, it had been kicking back when the rope was pulled, thought it broke my finger, Sunday I went to start it, it kicked back, then nothing, engine spins, has compression...