Recent content by chazdo2

The clutch / brake when released cuts out the engine. I have the seat switched jumped and the two switches activated by the clutch/brake arm work fine and tested good. Tearing my hair out. Anybody know why or have a wiring diagram? Cant find one anywhere!

same problem guess ill buy a carb they are cheap thank you though

did that too!

I have a TD 280 self propelled with the 725 Briggs EX engine. Starts right up dies within seconds. Completely cleaned the carb, gas cap vent works, new air filter , gas tank in line screen cleaned, new spark plug. Rubber gasket and plastic ring in the carb on the intake pipe are perfect...

I have that parts list but was looking if made a whole spindle thank you though!

Im trying to replace the deck spindles on my Regent model 2690572, 38 inch deck. Don t want to buy the parts for it was looking more for an aftermarket spindle complete. Cannot find any! Anybody know if any other brand or different mower spindles will work?

Thanks Ill try it all today!

Im trying to fix this side by side. Hesitates during acceleration. Dont know where to start . Have minimal experiance with deisel anything.

Thanks a ton!!!!!!!

6 X 2 all fuses are good under the dash 4 of them.

This is it

Johndeere gator wont start ! Any help? where to start?

The engine turns over the keyway on the flywheel is not broken. I was asked by a friend to fix it after he heard a loud bang. Just spins and valves don't move on either side. Camshaft broke? Any help appreciated!!!

I pulled a 20.5 briggs out of a running mower and now I have no spark. It has three wires coming out of the engine. two in a connector that are red and white. The third is a single yellow one in a connector. Anybody know where to wire these up?