Cfs's latest activity

Auto Doc. The new OEM part I ordered from a Exmark dealer did not come with a D adapter. Aren’t they normally included with a new...

Thanks to everyone for their helpful input. I installed the D adapter and it seems to have stopped the chatter when idling. In...

I wish I had researched replacing the clutch more thoroughly. I was under the impression that I had to hold the crankshaft by the...

I can do that. I was looking at a video from a PTO/Clutch manufacturer Xtreme Power in their installation video on their website it...

Here is a photo of the IPL

When I look at the Exmark IPL it shows several additional washers that I didn’t remove. This makes me wonder if this is a replacement...

I am replacing a defective PTO/ Blade Clutch on an older Exmark 60 inch zero turn. It is a model LZS27KC604 serial number 949453. I...

I tried to type the word SIDE but went right on the S and then went left on the I and the word DUDE appeared!! I always attempt to...

I attempted to type the word SIDE and my fat finger hit right of the S and left of I and the word DUDE appeared. I try to edit before...

I opened a new thread to as an upside downside of the 121-9100 pulley. I hope someone who knows will reply

I have a model 20200 Timemaster 31200 serial series. I removed the spindles and the black plastic cogged pulleys to clean the spindle...

I am asking if the 121-9100 pulley goes onto the shaft double d center side or round center side first

I am asking about the big black plastic pulleys, the ones that the cogged belt mesh with. There is a side that has a round metal center...

Question on the 121-9100 spindle pulley which is pictured in this post. Which side of the pulley is the upside and which is the down...

Thanks for the info. I did get the inner race on the existing bearing freed up somewhat. What seems funny is that the shaft seems to...