Have a 716 hydro. Worked great last year, now the rear end/tranny seems locked up and wont move. Checked the belt, fluid and filter all seem ok. Any ideas? Not very familiar with these tractors but would like to get it fixed. Oh and is there a way to disengage the rear end so I can move it...
Have a 716 hydro. Worked great last year, now the rear end seems locked up and wont move. Checked the belt, fluid and filter all seem ok. Any ideas? Not very familiar with these tractors but would like to get it fixed. Oh and is there a way to disengage the rear end so I can move it?
Could...
I have a murray 18hp. Have model # and tried the murray site with no luck.
Model #6 39004
manufacture date: 1136
Need wiring diagram and any service info.
Thanks
I have a murray 18hp. Have model # and tried the murray site with no luck.
Model #6 39004
manufacture date: 1136
Need wiring diagram and any service info.
Thanks
I have a 14hp Kohler command on a Dixon ZTR4422
I am looking for any service manuals that are out there.
Model#cv14s
spec#ps1428
Is there a compression release on these engines?
It cranks very hard, drains battery, sputters and wont take off. Any info would be appreciated.
Thanks
I am needing some dimensions for the stabilizer bars that connect the mower to the frame and keep it from shifting around. I have included a pic, they are part #6. This is off a 90' ranch king with 38"deck. PN711-0790a. If anybody can give me the length and any other dimensions so I can fab...
I have an early 90s ranch king, made by mtd, rider and cant get the deck to adjust right. I have been looking over the manuals and it appears that there are two stabilizer bars that are attached to the frame up by the motor and hook into the bars holding the deck on. My mower doesnt have these...
I have an early 90s ranch king, made by mtd, rider and cant get the deck to adjust right. I have been looking over the manuals and it appears that there are two stabilizer bars that are attached to the frame up by the motor and hook into the bars holding the deck on. My mower doesnt have these...
I have an early 90's ranch king mower with a 12hp briggs motor. I cant figure out the wiring to get it to start with the key. I can bypass the solenoid(screwdriver across the posts) an get the motor to crank. I replaced the solenoid and the ignition switch, still wont engage starter. The new...