Auto Doc's's latest activity

Hello P., The only adjustment on the carburetor is the idle stop screw with the Phillis head. The generator governor and tension adjust...

Hello J., Remove the screws from the right side (has seated on the machine), lift up the control panel and look for a red or black...

Hello Up, Would you mind sharing the information about what product you used? I'm sure there are others who have or will run into this...

Hello P., This problem sounds like a bad float needle allowing too much fuel to flow past it and the seat. The needle acts like a fuel...

I don't deal with Facebook. Do you have an actual link that you can attach?

Hello S., For future reference: It is best to provide us with the product identification label information of the machine. This...

Hello D., Pardon the observation. but you did mention the "USA". We are in modern times where most young people are just breathing...

Hello D., Give them a chance to make it right before you throw them to the curb. Parts frustrations are not easy but give them a chance...

Hello P., I help folks in my area with generator issues and sizing quite often. It amazes me how many people do not understand...

Hi CG, That looks like a match in pictures and on Parts Tree. Winner!

Hi MParr, That deck uses a wide front roller in the middle instead of the single wheel. It does look very close though.

https://mowerpartsland.com/product/bolens-lawn-mower-11a-414a065-carburetor/?msclkid=ca6703bbc52610fb5c936b45e49efc61

Hello B., Unless the carburetor is badly damaged due to water in the fuel, I suggest a full rebuild or get a replacement carburetor...

Aluminum will still oxidize back to a duller finish.

Hello H., Most Husqvarna decks are gray for the ones I have dealt with. I have seen a rare few early Scotts brand mower decks that...