Auto Doc's's latest activity

Hell D., These are known as a Belleville spring washer. Cup towards the pulley, raised center so the nut or bolt can tighten against...

Hello L., We've all been there before and will catch ourselves going there again. LOL

As the saying goes... they say, "it fits", but that does not mean it works.

Hello P., This is only a 10,500-Watt steady power unit. That is too small to run a whole house in my opinion. People often pick too...

Hello P., What are you planning to do with the generator? If it is for emergency standby? Anything below 12KW running watts is a waste...

I'm guessing it's from an 80's Simplicity or Ariens because of the 3 front wheels and the greaseable spindles.

Hi P., Please don't mix subjects. Open a separate thread post to discuss portable generator choices.

Those long screws (studs) that hold the carburetor on have a star on the tip that require an E-torx bit to take out. The studs each have...

Hello L., That is uncommon, but not unheard of. Check for power with a test light, but also verify the grounds are good. Do you have...

If you unplug it and check resistance and get no reading the windings are open in the PTO clutch. You will need a new clutch assembly.

Does this model have a 2 wire pto clutch like most do?

Hello L., If you have a multimeter, Ohm the 2-pins going to the clutch with it disconnected from the chassis harness. If you don't get...

Hello C., Check the piercing spring at the end of the coil wire, it attaches to the plug that is covered by the boot. I have seen then...

https://www.ebay.com/itm/314997900457?chn=ps&norover=1&mkevt=1&mkrid=711-167538-502585-0&mkcid=2&mkscid=101&itemid=314997900457&targetid=...

Three things that have bailed me out when I run into this problem with Phillips screws. 1. Make sure you have the right size driver...