Auto Doc's's latest activity

"If it don't, fit force it". LOL

This is a single belt drive pulley with a 1.25" tube extension on top and bottom (As measured from the pulley edge across to center...

Hello hlw49, The first challenge is finding an old school machinist that even knows what they are asking to be done. Second would be...

I hear crickets chirping.... We don't bypass thing here; we diagnose and repair them properly when it comes to an actual technician...

Hi Chuter, Back in the 80's Snapper 26"-30" RER mowers had bolt on "high lift" wings for the single blade intended for high lift bagger...

I went back through most of the posts, and this is pointing toward the fuel tank having to be removed emptied, then flushed out and left...

Use a rake and a broom for a few months and get back with us.

Hi Prada, If you like to clean and wash your equipment on a regular basis, they are great for blowing off all the excess chaff and...

Take it back to Home Depot and have them do a one for one exchange, or they contend with a local dealer to get warranty addressed. You...

Hello ACF, Check on Ebay for a "small engine cylinder hone". (They are very affordable) They have 3- stones usually. You need a fine...

Hello sano888, Most likely, the starter Bendix gear has split in half or sheared the teeth off of it. I recently repaired Kohler 22 HP...

Hello Just Don: Craftsman sold a couple of different designs. A couple of pictures would help us to help you sort this out.

If you are going to switch back later, I would leave them in place.

As I recall the JD L100 was only built for a few short years for the big box stores and discontinued due to low sales and chronic...

The issue may be with the generator section and not the engine.