Auto Doc's's latest activity

Sounds like the throttle cable jacket is not properly locked into the handle retainers.

Hi StarTech, They should all work under 20 psi if the regulator is lowered down to 0 psi and pressure gradually adjusted up once it is...

I have genuine 1-1/8 V-belt drive pulley from Craftsman rider if you are interested. It has the crank key made into it.

Does the tensioner pulley spin freely without growling noise? Is the tensioner arm moving freely and no wobble? Is the tension spring...

Chain link fence piping is usually thin wall construction and galvanized, any kind of welding will be a challenge.

So what happened was we were cruising just fine after the fixes I put in months ago, but then a couple of days ago a bot hit us (and...

Hello Mac29, Let us know what you need help with. Make sure to always provide your machine product serial number label and engine...

Hello Mike, Place 2X4's on each side under the outer edge of the deck housing, then lower the deck so it can rest on them Where the...

You notice that threaded rod? That is for making a manual adjustment when the blade wears the ends down. Pull the clip out and turn the...

Hello SamB, I would say "let sleeping dogs lie". Engine flush can easily do more harm than good because it is formulated with release...

I see you are new to this site. Welcome. Be aware that we need the machine product identification label information (PIN). Some people...

Sounds to me like the belt tensioner pulley is getting hot and locking up. That will slowly burn up a belt. Are you using OEM belts...

Hi Robert B., There is a pulse type fuel pump that has the 2 fuel lines (supply and carburetor) and then a 3rd line for the crank case...

I didn't notice the OP date. Oops! Lingering site clutter strikes again.

Can you pick out one in the list...