Recent content by 67ghiaTIV

SOLVED Ended up being the new wire i installed. The original coil Black kill wire has diodes in it to prevent the coils from interfering with each other. I patched together the old wire and all is good.

Good idea

My apologies. I was understanding probes touching together is continuity. Reading 0. Probes not touching reading 1 etc is a break or no continuity. Looks like i was misunderstanding. So a reading of infinity or 0 is continuity. My apologies.

Just checked the spark again. Nice spark on both plugs with coil black wires removed. No spark with black wires on coils. Parking brake on. PTO off. Sitting on the seat.

I just went through it all again from the first post with neg remove and grounding on engine block. No change

Still No continuity with ignition off and both kill wires off the coils. One coil wire in air, lead connect to other coil wire. Other lead the neg on battery. Still reading 1 on multimeter set to ohms Thanks for helping. Ill keep following your suggestions Jamie

Correct. No continuity on any test. We just tried again. We get continuity when leads are touched together.

We have No continuity. We haves tested the seat, brake, and PTO. Each switch showed contacts opeing and closing.

Briggs Intek on a JD 125 Riding mower. No spark. Friend brought it over. Got it running. All was good. Saw a mouse chewed on the coil black wires. Repaired and replace the wire. Put back together. NO Spark. Disconnect the black wires from the coils and we have spark. Checked the new wiring...