John Deere L130 Kohler no crank, ground wires that don't seem to go anywhere

[ptim]

I have a John Deere L130 that I used last week. Went to start it today and it will not crank. As I am trying to track electrical problems, I found a paired ground wire set that runs to a connector that isn't connected to anything. It comes out near the starter/solenoid, but there doesn't seem to be anywhere to connect it. Any help identifying where it is supposed to connect would be appreciated.

 

[GearHead36]

Is there an empty connector, lug, or terminal on the solenoid?

 

[StarTech]

That should have wires 105 and 115 which is a left over from the L100 - L120 wiring where they used a remote starter solenoid. Not used on the L130 solenoid shift starter.

 

[ptim]

That should have wires 105 and 115 which is a left over from the L100 - L120 wiring where they used a remote starter solenoid. Not used on the L130 solenoid shift starter.

Thanks, that solves a nagging issue. Way too many problems caused by bad, broken grounds and at least now I can eliminate these wires as a concern.