This simple fixture ( assembled with Elmer's ) works on any mower that has blades narrower than the trough area. Works on my old Murray 2 blade, my JD 2 blade and my son in law's JD 3 blade. I suppose it would work on a 5 blade too. It lays on top of the blades ( trough side down ) open end ( no sides ) extended from the blade tip end some. No clamping or fastening necessary. I begin with the right hand blade and work across removing the blades. Re-assemble by reversing the order.
Is anyone aware of a blade removal tool/clamp to make changing blades easier? I know that Arnold makes a clamp but that it's for up to 42" decks.
This simple fixture ( assembled with Elmer's ) works on any mower that has blades narrower than the trough area. Works on my old Murray 2 blade, my JD 2 blade and my son in law's JD 3 blade. I suppose it would work on a 5 blade too. It lays on top of the blades ( trough side down ) open end ( no sides ) extended from the blade tip end some. No clamping or fastening necessary. I begin with the right hand blade and work across removing the blades. Re-assemble by reversing the order.