Weed eater will not stay running

[fixit]

My craftsman gas weed eater will not stay running. It also leaks fuel. I have already replaced the fuel lines. I can get it statred in choke mode but it will only run for a few minutes and cuts off. While running, as soon as I apply the throttle it cuts out.

Any sugguestions please?

 

[msaeger]

Sounds exactly like the ryobi one I got off craigslist Mine leaks gas because there is a crack in the tank. I don't know how to fix the poor running. On mine it will do that then after it gets warmed up it works ok. I just plan on buying a new one.

 

[Tommyboyxd]

Just a few thoughts, you may have already done, but I throw them out there.

Have you changed out the spark plug?

And are you using gas from last year? Or do you have the right 50:1 mix?

And last, how is the air filter? If it is super dirty you will want to clean it or maybe replace it.

 

[Winger]

Pinpoint the gas leak first. It may be a carb gasket or just a faulty carb. Then once you got that cured use fresh 90 octane gas for starters and check the idle screw as it may be set low.

 

[Ifixdit]

My craftsman gas weed eater will not stay running. It also leaks fuel. I have already replaced the fuel lines. I can get it statred in choke mode but it will only run for a few minutes and cuts off. While running, as soon as I apply the throttle it cuts out.

Any sugguestions please?

If it's the carb leaking, your needle is most likely not seating properly.

 

[CauZey]

I have a toro doin the same thing. New lines, clean fuel , new filter fuel and air . Starts on choke runs a few moments then kills . If you give it throttle it will die every time.

 

[Toro1]

My craftsman gas weed eater will not stay running. It also leaks fuel. I have already replaced the fuel lines. I can get it statred in choke mode but it will only run for a few minutes and cuts off. While running, as soon as I apply the throttle it cuts out.

Any sugguestions please?

Two things come to mind:
Verify that the primer bulb is filling w/fuel when pumping to prime unit. If not, you have a carb/diaphragm/primer bulb issue.
If primer is ok, turn the 'L' mixture screw (closest to the engine) 1/8 - 1/4 turn counterclockwise and see if this improves the performance.
If this improves the performance, let the unit warm up w/choke off. Burp the throttle to hi speed. If the unit responds w/o hesitation or stalling, you're done. If it still bogs down a little before hitting full rpm's, turn the 'L' screw counterclockwise another 1/8 turn and repeat the throttle test.

 

[RussellTP]

I remember that I removed the muffler and cleaned out black buildups inside the port. It ran great.:smile: