Swisher XZT60 Blowing Fuses

D

Daisy@25

Forum Newbie
Swisher XZT 60, 25 horse, model-ZT2560 serial- L106-103106
My Swisher keeps blowing fuses every time I turn the ignition switch to start it they blow immediately. I have replaced the solenoid, ignition switch and chased all the wiring. I can't see any wires that are bad or misplaced. The battery is right as well.
 
Did you test every safety switch and PTO switch? How did you test the wiring harness? Finding a dead short to ground can take hours on today’s equipment even with a wiring schematic. Even longer without. Need a good VOM, a couple of different jump leads, an understanding of how the different switches work, (some are NC and others NO and some use relays) plus a good assistant.
 
You must log in or register to reply here.
Back
Top