DUSTYDOGMYERS
Forum Newbie
- Joined
- Jun 8, 2015
- Threads
- 1
- Messages
- 1
HAVE OLD B&S MOWERS WITH PULL START SPRAG CLUCHES. NEED TO KNOW HOW TO INSPECT, CLEAN, AND PROPER INSTALLATION.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
SPRAG CLUTCH CLEAN/REPAIR/INSTALLATION
- Thread starter DUSTYDOGMYERS
- Start date
More options
Export threadHAVE OLD B&S MOWERS WITH PULL START SPRAG CLUCHES. NEED TO KNOW HOW TO INSPECT, CLEAN, AND PROPER INSTALLATION.
I have done this on my own mowers only about 6 times. Take top cover off mower and you will be able to take clutch apart and clean and lube it but not with grease. That will make it stick. Use a spray lub. Watch out for coil spring, if it unravels its hard to get back on. Hope this helps. I am no expert. I just saw where no one else answered you.
Just clean it real good, I wouldn't put any grease/oil inside starter clutch with the ball bearings. Ball bearings need to be dry and clean. I usually dab just a little grease near end of crankshaft.
Inspect where metal contacts metal or plastic, ball bearings- inspect.
Installation reverse taking it apart.
Inspect where metal contacts metal or plastic, ball bearings- inspect.
Installation reverse taking it apart.