JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser .
Jul 28, 2022 #1
M
mrgutzmer
Hello,
I have been searching for the torque specs for the four little housing bolts on the spindle for a John Deere la175. The housings are aluminum, I want to get them tight, but not so tight as to strip out.
Jul 28, 2022 #2
M
mechanic mark
Apply antiseize compound to bolt threads & install & tighten until snug. Auto parts stores have small packets of antiseize compound.
Jul 28, 2022 #3
B
bertsmobile1
Do them up til they stop moving in then 1/4 turn
Alternative do them up till they go loose then back off 1/2 turn
Jul 29, 2022 #4
StarTech
Those should either 5/16" or 8mm self tapping screws. Dry up to 12 ft/lbs. Lubed up to 9 ft/lbs.