paulbaker1954
Member
- Joined
- Sep 27, 2023
- Threads
- 5
- Messages
- 13
Hi
Anyone have or can point me to a wiring schematic for this mower
Anyone have or can point me to a wiring schematic for this mower
MTD J/136 Wiring Schematic wanted
- Thread starter paulbaker1954
- Start date
paulbaker1954
Member
- Joined
- Sep 27, 2023
- Threads
- 5
- Messages
- 13
Thanks, I had already found the same, what I really need is a schematic showing switch n/o n/c connections plus ignition switch connections. Similar to the attached
Attachments
- Joined
- Feb 19, 2020
- Threads
- 118
- Messages
- 12,658
That diagram does gives you the ignition switch connections. But you to lookup the safety switches for make/break config which should NC/NO setup. Just got to think a little.
It is better than some the latest line drawings I have to deal with that takes several hours to label here. Those manufactures don't care if it takes us tech hours to figure out the circuits.
It is better than some the latest line drawings I have to deal with that takes several hours to label here. Those manufactures don't care if it takes us tech hours to figure out the circuits.
bertsmobile1
Lawn Royalty
- Joined
- Nov 29, 2014
- Threads
- 65
- Messages
- 24,995
Easy peasy
The wires that go to the magneto will connect to ground to turn the engine off
Thus the brake & PTO will be N/O
The wires that go to the starter solenoid will pass battery voltage to the starter when the PTO is off & the parking brake is on as they are a daisy chain
The 4 pin plugs will have one side N/O & the other will be N/C
Seat can be either way if it is a 2 pin plug
The wires that go to the magneto will connect to ground to turn the engine off
Thus the brake & PTO will be N/O
The wires that go to the starter solenoid will pass battery voltage to the starter when the PTO is off & the parking brake is on as they are a daisy chain
The 4 pin plugs will have one side N/O & the other will be N/C
Seat can be either way if it is a 2 pin plug