Hustler Super Z/60" xr-7 Deck, Idler Pulleys

Skippydiesel

Well-Known Member
Joined
Nov 29, 2020
Messages
521
My Hustler project has four idler pulleys. Three fixed, one tensioner.

The two front ones feel loose - would like to replace them.

Shaft OD 5/8"
Two front are the same 6 3/4" OD, approximately 3/4 height, 21/32" ID (inner bearing). Both black, flat , assume welded.
One (Good) at the back, same OD, approximate height 31/32", same ID (inner bearing). Silver appearance, riveted, made in Milwaukee.

So far have only been able to find replacements with 11/16" ID. This will be very loose on the 5/8". What to do? Please advise.

Thanks :devilish:

Note: Photo off internet, for illustration

1794872703290.png
 
I am fairly certain that is the correct deck IPL. But without the mower model it hard to tell as they might have changed them.

The 781385 [Rotary 10226, Stens 280-838] will be find as it is the stand-offs that fit the pulleys and capped with 1 inch washers. If it weren't for the stand-offs the pulleys would never turn.

The Stens are 1-1/8" height vs the Rotary at 1-1/2" OD 6-3/4" with the flats on both at 6"

Moving idler is 781856 [Rotary 12696, Stens 280-874]. The Stens is 1-3/8 height vs the Rotary at 1-5/16" OD is 5-3/4 with the flats at 5".

ID of all bearings are 11/16".

BTW I have installed 6 of the Stens 280-838 on at least 3 XR-7 decks without since 2020. Two if them have been on the customer's Super Z across the street since 2022.
 
Back
Top