Export thread

Hello

#1

S

squaredeal

New member here-have been reading and learning for a while-now the post with a need:
I have a 2003 Dixie Chopper w/990 Generac engine and having difficulty locating primary and secondary air filters. Dealer offers are 1 " too short and cannister cap does not seal when locked. Does anyone know of third party sources that might be affordable-the Dixie factory says they have them at $92 each. Perhaps I mite purchase the shorter cannister for the shorter filters. Your knowledge and opinions are much solicited.


#2

A

Auto Doc's

Is this what you have? Usually only the large outer one needs to be replaced.



#3

S

squaredeal

Thanks so much for the input.
I don't believe the filters you identified are the ones I current have installed--the length (of both ) is 11 1/4". The one above are those available from dealer.
As I see it, there are two options? (if correct length cannot be located)
1. devise a 'filler' to take up void between end of filter and inside of cap
2. locate and purchase cannister housing to hold the shorter filters
If you or anyone can offer ideas, thoughts -I am most certainly thankful and open.

You are correct about the primary usually only needs replacing-I try to keep it clean with compressed air as Dixie Chopper info recommends.

On a side note: it appears as though I have similar situation with my New Holland compact tractor-it uses same filters.
Once again-I thank you for your input and look forward to a solution soon.


#4

A

Auto Doc's

I think the later model Generac generators had a similar filter system after the change their designs a little and got away from the square top mounted filter assemblies.

More than likely Baldwin brand filters might have a match for your dimensions.


#5

S

squaredeal

OH! thanks so much for a direction.
I'll let you know how it 'filters' out!


Top