Export thread

Deck leveling and pitch adjustment

#1

M

Mike19481962

Have a 2011 Gravely Compact Pro 34 zero turn I am trying to make deck adjustments. The cutting height is set to 3". When I lower the deck the tips of the blades left to right and front to back are about 1/4" high. The deck leveling adjuster bolts are screwed out so there is no lowering the deck. What am I missing?

Attachments







#2

A

Auto Doc's

Hello Mike,

Place 2X4's on each side under the outer edge of the deck housing, then lower the deck so it can rest on them

Where the cross bolt goes, it appears to have a slot in the arm for the main adjustment, then the vertical bolt with the locking nut is for fine adjustments.

Loosen the hardware and adjust accordingly.

Gravely Compact Pro 34 Operator's Manual (Page 27 of 36) | ManualsLib

www.manualslib.com www.manualslib.com


#3

M

Mike19481962

Auto Doc's said:
Hello Mike,

Place 2X4's on each side under the outer edge of the deck housing, then lower the deck so it can rest on them

Where the cross bolt goes, it appears to have a slot in the arm for the main adjustment, then the vertical bolt with the locking nut is for fine adjustments.

Loosen the hardware and adjust accordingly.

Gravely Compact Pro 34 Operator's Manual (Page 27 of 36) | ManualsLib

www.manualslib.com www.manualslib.com
Click to expand...
Ok, I will try that, and thanks for your help.


#4

M

MParr

If it were my mower, I would run it level all around.
If you are going to do it by the book, match your height selection to the actual cutting height in the front and raise the rear 1/8" to 1/4".


#5

7394

7394

And know when you get on the mower, height will be a bit lower from operator weight.


Footer Links 1

Top