You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser.
#1
Jeanphilmartel
Engine run good , no problem but when I hit the blade switch it take 2-3 sec and engine lose power and died !! Please help me
#2
K
keakar
it wasnt in reverse was it? it happens
test the operation of the spindles and pulleys to see if they are free or if the bearings are shot
#3
N
nbpt100
If KEAkar's ideas did not solve your problems check to see if the Carb is too lean. If you can richen the mixture try it.
