I have a 42 in stamped deck Husqvarna YTH20F42T mower that I need a bagger for. Husqvarna says that bagger H342SG is the one I need but it has been discontinued. Someone on ebay is selling a generic bagger that is basically a craftsman
24898 and they say it will fit my mower but the bracket for it is different than the one in the diagram for the Husqvarna H342SG. I'm wondering if anyone has either of the baggers and could take some measurements for me.
Should do.
All of the pressings are done with the same dies
The size & shape of the discharge hole varies between the different models so you might need to be a little crative with some gal iron & tin snips .
Thanks Bert but the part I need to verify is the bracket that attaches to the rear of the tractor. I need to verify the width of the bracket between the tabs and the height of the tabs relative to the pin on the bottom.
