Export thread

11hp vert. briggs engine problem

#1

B

bebuzz69

i have a 11hp briggs vert. engine old type with the solid type carb the number is 252707 0660-01
and where you have the control plate for the throtle and choke. One of the small holes that hold the plate on is stripped.
do you think jb weld will hold new threads.


#2

B

bertsmobile1

no
but the shaft with the plate on the top is replacable.


#3

T

Tinkerer200

bebuzz69 said:
i have a 11hp briggs vert. engine old type with the solid type carb the number is 252707 0660-01
and where you have the control plate for the throtle and choke. One of the small holes that hold the plate on is stripped.
do you think jb weld will hold new threads.
Click to expand...

Drill the hole in the plate a little larger and use a self tapping screw or even a sheet metal screw.

Walt Conner


#4

B

bebuzz69

i went to buy some self taping screws but they seem to long. can i drill the hole deeper or will i break into the sump.
i can grind the screws down but then there are hardly any threads left.


#5

T

Tinkerer200

bebuzz69 said:
i went to buy some self taping screws but they seem to long. can i drill the hole deeper or will i break into the sump. i can grind the screws down but then there are hardly any threads left.
Click to expand...

I would not drill deeper, use sheet metal screw.

Walt Conner


#6

B

bebuzz69

thanks try it tommorow.


#7

B

bebuzz69

put screws in and works fine, thank you.


Footer Links 1

Top