gasket

I have to put a new sump gasket and governor in my 422707-121401 Briggs Engine is off machine and on bench 6 bolts removed from sump! This thing is on tight rubber mallet not working don't want to damage anything any ideas Afraid to keep beating on it!

intek 12.5 hp engine cylinder head gasket need to confirm part # here’s the engine I have image I believe I need a new cylinder head gasket but don’t know the part # do these #s ingraved on valve cover tell what type of engine this is? maybe this image like do I have to measure heres old...

Intek 12.5HP cranking but not starting fuel coming out exhaust manifold gasket the bolts holding the exhaust manifold on are tight. could a blown manifold gasket prevent ignition? The carb was run dry as I do whenever done mowing , I drained the old fuel inside take. The engine turns over my...

I have a rider with a 16.5 horse Briggs and Stratton, I/C, OHV. I took the valve cover off to adjust the valve lash, and spent five times as long to scrape gray RTV off the head and valve cover. I made a gasket from paper gasket material (plain gray stuff) - will that work or should I plan on...

Greetings. I'm changing the carburetor on my 23 HP Briggs V Twin on my JD Zero Turn. The new carb comes with gaskets, which include gaskets for the intake manifold (see attached), which are different than what I found when I removed the carb (O Rings). So, when installing the new carb, should I...

Hi All , First off: Kohler CV675S Spec 75544 Serial 3130209491 Mounted on Craftsman GT 3000. After 23 years, It blew a head gasket. What I’m looking for is part numbers for the current Head gasket kit with all other associated gaskets. If I’m doing one, I’m going to do both. Also, it has...

Victa Mustang 18 Ultima 4 stroke 5 hp (1994) lawn mower with Tecumseh engine. I thought the starting problem was fixed by changing the ignition module, but today, after 2 weeks' absence, the same starting problem has reappeared. After priming many times, the engine starts at the first pull, but...

Am going to do a valve gap adjustment, 1st time, FX481 and am wondering if l need to use a smear of rtv silicone with the new gasket or install it dry?