I wish I could find the post from about 2013 where someone said to clean out the pilot jet on the side of the carburetor before doing any further carb work. This was a very quick fix on my mower that was loping badly. Eventually I suppose I should take the carburetor off and clean it.
Now the pilot jet is not staying tight in the carburetor body. I am afraid to tighten it too much and possibly ruin the plastic. Does anyone know if it would be okay to use a little Loctite to hold the pilot jet?
Now the pilot jet is not staying tight in the carburetor body. I am afraid to tighten it too much and possibly ruin the plastic. Does anyone know if it would be okay to use a little Loctite to hold the pilot jet?