Finally got it off. Had to jack up the floorboard six inches for the arm to clear.[/QUOT
The part I am referring to is thee "Mower Rear Link RH (right Hand) #K2581-44202. It passes through the frame. The arm on the right hand side of the tractor needs to be rotated straight up in order for the triangular plates to pass through the triangular holes in the frame. But, the floor plate and fender are in the way of rotating the arm. Now, you can take all this extra stuff off the tractor to rotate the arm. But, if careful, you can jack up the floorboard slowly so as not to break anything until its high enough to rotate the arm. Then you can get the old link out. Right after installing the new link, put the bushings back in place before you connect up the Left hand mower link or there will not be enough play to install them. After that it is all downhill.