I cleaned the carb put it back together (did it few times already)
2 turns out on the pilot screw and 1.5 turns on idle stop screw
with the governor rod set to about 90degrees to whatever rod its mounted on it runs and idles good but the rpm is too low so it stalls when under load
if I adjust governor rod ccw a few degrees it runs faster but dies as soon as the blade is engaged.
2 turns out on the pilot screw and 1.5 turns on idle stop screw
with the governor rod set to about 90degrees to whatever rod its mounted on it runs and idles good but the rpm is too low so it stalls when under load
if I adjust governor rod ccw a few degrees it runs faster but dies as soon as the blade is engaged.