Integraoligist
Member
- Joined
- Nov 4, 2012
- Threads
- 5
- Messages
- 14
Hey all, been trying to figure out the issue with a Toro 22" Recycler...
When you pull it from a cold start, after a few pulls it will start for a few seconds, runs like it's at 1/2 power, then dies.
If I prime it, then pull... it never fires... after pulling and pulling it will eventually do the same as listed above.
Changed the plug, cleaned the wires, changed the oil, checked the resistance of the blade... everythings all good, tested again, and all still the same result as above.
Pulled the carb, the jet and the bowl, all are clean, but cleaned with carb cleaner anyway... tested fuel getting into the carb, all good. Tested.... still the same as above.
Any ideas on what the next step is? Not sure what else it could be.
Thanks all!
When you pull it from a cold start, after a few pulls it will start for a few seconds, runs like it's at 1/2 power, then dies.
If I prime it, then pull... it never fires... after pulling and pulling it will eventually do the same as listed above.
Changed the plug, cleaned the wires, changed the oil, checked the resistance of the blade... everythings all good, tested again, and all still the same result as above.
Pulled the carb, the jet and the bowl, all are clean, but cleaned with carb cleaner anyway... tested fuel getting into the carb, all good. Tested.... still the same as above.
Any ideas on what the next step is? Not sure what else it could be.
Thanks all!