Search results

All, OK, the deed is done! Chain saw is working great with new carb: https://smile.amazon.com/gp/product/B07MR29YS4/ref=ppx_yo_dt_b_asin_title_o02_s00?ie=UTF8&psc=1 Here are some photos: I bought a new Dremel tool (which I have always wanted) and ground off the two tits on cylinder side...

Dougand3, See photo, the carb I bought did not fit on the cylinder side opening, due to the two alignment tits on cylinder do not have any place to go on the carb! As you can see the original cylinder gasket is shown with the two tits. So far I can't find a carb that will seat on the...

All, One more question... See photo See the little loose piece that goes in the long oval hole... it looks like a little spoon.. wondering which way you install this, is it with the depressed/rounded part DOWn or UP? TIA, Greg

OK, took out the h/l screws, took carb apart, see photos. I'm concerned about two things before I put it back together. 1. See the photo of the pump side where I show there are 3 gaskets, doesn't seem right to me. Shouldn't there just be one thick gasket and one thin gasket? 2. See photo...

Hi, As you described I was able to reroute the three fuel lines properly, prime bulb worked fine and drew fuel through carb and back into tank! I got it to run smooth for a minute or so, then stalled. I got it started a second time also, then stalled quicker. Then what I tried to pump the bulb...

Dougand3, Thanks very much for your excellent reply! Performed step 1.: after 20 pulls , the engine started right up and ran for about 15 seconds, then stalled. So, then I'm thinking fuel system problem... I pumped the bulb about 4 times and then pulled a few times and it ran again for 12...

Hi guys, I have a McCullough MAC 3200 with a symptom: will not start Here are some photos: I have fresh gas in the tank, bulb priming seems to work fine, checked sparkplug it looks new; removed the muffler, closed the choke. Tried pulling the rope and there are no sounds of it...

All who posted, Ya'll were correct, I had the lines reversed! I got a good piece of tygen and use that for the bulb line. Then look at attached photos, you can see how I solved the grommet leak by using a small piece of rubber from a physical therapy exercise band! Problems solved...

HI, I have a 25cc model: 3HCPS.0254AE Symptom: If gas tank is really full, string trimmer works fine for a while. Right now my tank is about 75%full and when I do get it started, it usually stalls engine quickly. It seems to have something to do with the angle I hold trimmer at. I will...