Search results

I have a Hustler Fastrak. I am thinking of adding seat suspension. Has anyone used this type of suspension? Seat Suspension Does anyone have recommendations?

That has been the only real issue I ran into so far. I had to grind the anchor off the Cub and weld it on the Hustler. I have a longer throttle cable on the way. The throttle and choke cable route on the same side for the FR and route from both sides of the engine on the FH. Hopefully not a big...

I have the complete mower with the Cub. It runs fine with about 500 hours it is just slow. Could I just use the Cub engine with the pto that is on it? I also wondered about the wiring. I see that the Hustler has a separate starter relay. May have to figure that out.

I have a Hustler with a Kawasaki FR691V - AS27 - Engine that has a damaged cylinder. I also have a Cub Cadet with a good Kawasaki FH721V-S01. Can anyone advise whether this would be a direct swap for the damaged engine?

I have a Husqvarna YTH1542 with about 500 hours on it. The mower runs and cuts great. For some reason the deck will barely raise enough to get the front wheels off the ground on a level surface. The only way I have found to get it ot raise any higher is to run the adjusting rods on the front of...