Search results

we are 300 miles from any kind of decent hardware store let alone a small engine shop. I will probably take it out and use a bow tie clip or a cotter pin Thx again

This had the old cup style that gets ruined when you take it off. I don't think this rod has a drilled end and I will have to take it out to drill it. I have lot's of the bow style.

any idea where i can find the phony clip that goes onto the rod?

Got it! Rod had fallen out. Thx for your help.

will check

ZT1 42 only turns in 1 direction

ZT 42 Cub cadet only drives off one wheel

I am working on a BS 44 m777 0148b1 that has no spark from either module. I have disconnected the ground wire and still no spark. It just doesn't seem right that both modules should go at the same time?

Ordered a head gasket kit. Thx. T

Thank you. I wiil check it out.+

Working on model 33S777 0004g1. It blows gray/blue smoke after running 2/3 minutes and the small vent on the fuel pump starts to leak oil. Is the diaphragm in the fuel pump leaking. It is the only thing that I can think happening. The oil level is fine (not over filled).

Does a Kohler H265 have a compression relief system?

No but that is next on my list. It almost comes up solid but you can pull it through and then it turns easy until the next time it comes up "really" hard.

I am working on a Kohler SH,6 1/2 HP motor that is hard to pull when it comes up against compression.

Check your battery!

never mind! Got it

How does it Work?

How does it ?

Both idlers look good and the belt measures 100 and 1/4 ". The mower doesn't seem to slip in forward gears, only in reverse.

OEM

I ran all the external tests and it does not turn rear wheels as per reverse function test. Its hard to turn and only one wheel wants to engage.

2 mowers both models 944.604260 Mower 1 ser.#050314A001991 Mower 2 ser#042514A002139 Both use belt # 197253 Mower1 has limited reverse, mower 2 has no reverse, both belts are turning the transmission Both mowers are Canadian

The belt is brand new. With the rear end lifted and the wheels off the belt is turning the trans, but as soon as a load is put on everything stops

I've got 2 YT3000 with no or very little reverse. Any fixes? Or is just plastic junk?

The choke on this unit is always partially om when running. Is there an adjustment for this. It is a Craftsman push mower with the "never add oil" model 104m020009f1.

how do i change the drive cluych cable assy.on a hrb215? tcn

testing a 500x and after mowing for a while (1 hour) the engine starts to bog and miss (almost like getting off the seat). If I let it idle for a minute with the PTO disengaged it runs well but only for 10 minutes and then does the same thing