Search results

Thanks, I'll do that tomorrow.

So this summer I was having sensor problems on my zero turn so I just re-wired it straight with new wires bypassing everything. It's been running great but I have to keep charging it. I see online if I wire the B+ terminal on the voltage regulator to "R" on the key switch it'll charge it...

After running fine for a while when it's hot, you have to choke it again and go through the whole process.

Engine: Briggs and Stratton 17hp Intex single cylinder. Mower has a new battery, new carb and a new starter. I also have checked the valve clearances and they are fine. Mower sometimes stops on the compression stroke as if the compression release is broken but I am positive the compression...

I think I finally figured out the motor. Its a Kohler CV747. Now I need to figure out why it sounds like the exhaust is going out the intake. I checked valves and did a valve adjustment. Nothing changed.

I'm to the point I am tired of my front tires getting bumped off the rim/ going flat or whatever the case might be. I need some help with what to purchase. Should I purchase the 5/8" center hole or the 1/2" center hole. Below is a link to what I am looking at...

I think I figured it out. I think its a ZVKH72303 I seen a pattern in the model numbers with the cutting width's. Kohler engine CV747

Does anyone know any info about my mower or where I can get good info. I've googled all the below numbers, i've searched, I am just not finding anything. Mainly what motor is on this. Its a Kohler Engine and its fuel injected but the silver sticker is gone off the blower housing. Yazoo Kee's...

Of course all my pictures are too large to post. I even tried to lower the quality and it's still too big.

My silver sticker is missing off the blower housing. Would anyone know what motor this is? Motor is on a yazoo keys mower. But when I look up any of the numbers for the yazoo it doesnt give me much. Right now the mower runs but its weak on power. Compression test numbers are good. When you...

Okay, thanks. Maybe I was over thinking it then.

I'm so fed up with this hack wiring job that someone has done on this mower before me. I know how to do this for Briggs motors and its pretty easy. Engine: Kohler SV730-3043 I'd like to know where the wire harness wires go (6 wires using 5 pin outs on a 6 pin out plug) , and where they go...

Hi guys, I need some help on finding the correct spindle assembly for my Hustler. Yes I've found the parts on some websites but they've got to be cheaper than 100 bucks for 1 spindle. Or someone knows of another spindle size that fits. Also what are good sites that have a lot of parts for...

I bought a wood chipper with a 5hp B&S motor and when I pull the pull starter it back fires a flame out the exhaust and wont start. What causes this? I googled some things but didn't find any real good answers.

I've been having problems with my mower lately, not starting from the key so I rewired it using my steps below. 5 prongs on the ignition switch- SBLMG S- post on starter solenoid B- Wire straight to the battery with a 20 amp fuse L- Red Stator Wire and Grey Wire from Carb M- Black Wire from...