Search results

Are all zero turn mowers with hydros pretty much run the same hydro pressures? What are the typical hydro pressures? Thanks in advance for your post!

I already have the pulley off & it looks very accessible. Would you have the part number for the seal? I think I will go ahead and change both hydro seals while I’m under it. One last question if you don’t mind? Is there a procedure and a product to use to flush a hydro system of contaminates...

The Scag M/N STCII-48V-23V an S/N 4601500684. Thanks in advance for any input!

Scag Tiger Cat II MN KT740-3042 2016 I need to replace a hydro drive shaft seal. Is it like replacing a crank shaft seat, are do l need to remove the pump to replace the seal?

I’ll put a few hours on it and post the progressive results it any. Thanks for your time!

Especially since all belts and pulleys are new?

Would it be safe to say that, “there is a approximate time for new belt break in” for belt whip action to stop?

Thanks for your response Lawn Addict. After 1 hour of use, with belts off all spindles spin freely an all spindle pulleys are secure. The 4 engine bolts are secure. What would cause belt whip action?

2016 48” Scag Tiger Cat II M/N STC II-48V-23CV, S/N 8900144 with a Kohler M/N KT740-3042 S/N 4601500684. The mower has a rough life due to the way previous owners had worked on it. 3 of the five deck pulleys were badly bent, the PTO had been pounded on with a hammer, the original engine had...

The cl Problem solved!! Thanks Star Tech.

It’s a 2016 48” Scag Tiger Cat II M/N STC II-48V-23CV, S/N 8900144 with a Kohler M/N KT740-3042 S/N 4601500684. I’ve researched everything that I can get my hands on an there are no parts measurements anywhere that I can find and assuming that this is the original engine that came with the...

Just picked up a 2018 Tiger Cat II and having to correct a lot of pretty bad mechanical faults caused by persons or person with less than 0 mechanical skills! I’ve replaced the clutch because it had been removed for some reason and when it was reinstalled it was beaten back onto the crank shaft...

Thanks for the reply! Would I check the coil by running a spark test while hot?

Mower: Scag SZL48-22KT, S/N K710317 Engine: Kohler KT725-3027, S/N K7100317. Spark is good, fairly new ignition coils and spark plugs and has correct air gap on both. Starting cold, pull out choke, engage starter and it starts within 5 revolutions. Mow lawn, shut down, restart, crack throttle...

If that’s the case I’m amazed at the power it still has, no smoke, no noise, does not use oil and always starts within a few revolutions and runs great. I guess it’s possible that the prior owner(s) could have rebuilt the engine?

Kohler 22 HP, M/N KT725-3027, Manufactured 10/2014 with 7500 hours. Before replacing parts and servicing it would start without choking when hot. Now on rare occasions it will start but most of the time I have to choke it and it starts after a few revolutions. 1. Replaced, coils, (original & 1...

New to forum a just replaced spindles on SZL48-22KT a can’t find the torque for the spindle pulley nuts. Would anyone have the torque valves? Thanks in advance.