Search results

Yes its made by snap-on and has the correct easy spring in it. thats all the pressure it has I would send a picture of the inside of the cylinder if I new how to get it on my puter

have the correct schrader valve in tester

ebay off brand like I say not scored just chrome shiney spot near the intake and exhaust port not a streak nothing to feel with fingernail. I get u that its not much of a saw. but ran before should run again. I remember hearing of rings not seating in a car engine I dont have much experience...

yes checked muffler did not do a pressure test but compression test was 45 tore it back down noticed a shiny spot near the intake port. and one other shiny spot. I think the ring didnot take or from what I read I have a glazed cylinder I am going to rough it up with red scotch bright and try...

The pisonr has .019 checking the ring gap with feeler gauge . This is over recommendations of .015. I ran when I first pulled it. smoked the oil off and it quit and will not start. Where can I get a ring without so much gap. One that actually fits.

I am finally getting back to finishing this thread and thank u for all your suggestions. It turned out to be a sticky float needle coupled with a non working anti-backfire cut off. after putting in new needle and a genuine gasket with small oring. It is running perfectly no chokeing needed...

Apparently this company is not set up to sell parts, or only the few that they list on there web site if some one new the dimensions of the ones that belong on it I would be able to find them elsewhere and for a reasonable price.

Yard sale find: This walk behind string trimmer mower has the v-belt tensioner pully and idler pulley missing. anybody know the diameter and or part numbers of a belt an pulleys for this thing? help me the name an model are not bringing up anything. This machine may have another name or model...

Thanks for the advice. Will update

Model 33R877 type 0002 code 140757

I’m not their now it is on a red craftsmen 42” cut

Runs fine with two fingers on the air intake or the choke about half on. yeah valves did not have any cuts blued them had contact

The surging has been going on for couple of years. The new carb did not help either new head gasket too of course

I changed the governor when changing the camshaft.

Yes

Changed carbs adjusted valves still the same thing hunts real bad only runs with choke half on. Changed carb head gasket and lapped the babes still hunts an dies without choke on

This one is slipping bad in reverse thats why i want to change it out. have some john deere transmissions tuff torque

What would be a good transmission that will fit this mower without a lot of modification. This mower has the foot shift

this zero turn mower came to me with both ignition coils not producing any spark. They were both bad. Its a kohler engine twin cylinder. That seems kind of odd changed them out with new ones. Installed a fully charged battery only to find its blowing fuses. Could this have caused the coils to...

Motor swap for craftsmen 420