Search results

I followed the advise on this thread Can't pull mower backwards McMaster Carr Part# 6391K214 .625" OD x .500" ID x .75" long. 2 bushings for each side. I just placed them inside the adjuster and it works smoothly. I did not epoxy them in place. I do think a small hose clamp would hold the...

Update... I replaced the plastic bushings in adjuster with oilite bronze bushing from McMaster Carr on the right side only. I also replace the pinion gear, washers and collars. All of the work was done on the right side only. I lubricated everything with bearing grease. The only issue is...

Another update. The adjusting arm for the right wheel has a lot of play in it. The adjusting arm for the left wheel has no wiggle at all. I guess the bushings in it are worn. Is this hard to change? Can I change just the bushings or is it best to go ahead and change everything while I am at...

This evening, with the new pinion gear on the right wheel. I pushed the mower on flat concrete. It steers right. I swapped the two rear wheels and wheel shafts and pushed on flat concrete. It steers right. I started the mower and let it drive on concrete, it steers right. I lifted the front...

I tried to do a search on this but didn't find anything. My Honda HRR216 self propelled pulls to the right while I am using the self propel. I had this issue last November (and the mower would not pull in reverse) and took it in for service. I was told that pinion gear had not been...