Search results

I have an old 72" Sabre Tooth Scag with a 31 hp 3 cylinder engine. It was very jerky to operate. Had to dealer and the mechanics could not figure out the problem as it only occurred at full throttle when mowing. Turns out there are 4 dampers that create drag on hydraulic motor levers. When...

72" Turf Tiger, 35 HP Vanguard engine. Some rope, suspect belt rope but do not remember this belt going bad and could not get clutch fully disassembled to examine further), got into clutch and caused it to go off balance and burned out. Also burned out PTO switch and voltage regulator. (Still...

The release lever is always covered in debris. It is on the left side (when seated) on the frame below the seat slides, about midway back from the front of the seat. The Scag ID numbers are there also once you clear the debris. If you have debris, you have to clear debris enough to fully move...