Search results

Are all zero turn mowers with hydros pretty much run the same hydro pressures? What are the typical hydro pressures? Thanks in advance for your post!

Scag Tiger Cat II MN KT740-3042 2016 I need to replace a hydro drive shaft seal. Is it like replacing a crank shaft seat, are do l need to remove the pump to replace the seal?

2016 48” Scag Tiger Cat II M/N STC II-48V-23CV, S/N 8900144 with a Kohler M/N KT740-3042 S/N 4601500684. The mower has a rough life due to the way previous owners had worked on it. 3 of the five deck pulleys were badly bent, the PTO had been pounded on with a hammer, the original engine had...

Just picked up a 2018 Tiger Cat II and having to correct a lot of pretty bad mechanical faults caused by persons or person with less than 0 mechanical skills! I’ve replaced the clutch because it had been removed for some reason and when it was reinstalled it was beaten back onto the crank shaft...

Mower: Scag SZL48-22KT, S/N K710317 Engine: Kohler KT725-3027, S/N K7100317. Spark is good, fairly new ignition coils and spark plugs and has correct air gap on both. Starting cold, pull out choke, engage starter and it starts within 5 revolutions. Mow lawn, shut down, restart, crack throttle...

Kohler 22 HP, M/N KT725-3027, Manufactured 10/2014 with 7500 hours. Before replacing parts and servicing it would start without choking when hot. Now on rare occasions it will start but most of the time I have to choke it and it starts after a few revolutions. 1. Replaced, coils, (original & 1...

New to forum a just replaced spindles on SZL48-22KT a can’t find the torque for the spindle pulley nuts. Would anyone have the torque valves? Thanks in advance.