Search results

*<sigh>* “If it’s not one thing, it’s another.” Thanks to the assistance of folks here, I solved my fuel supply issues on my old LT1046 and last Friday knocked down the thigh-high weds that had grown while it was out of commission. But when I went out this morning to give it a second cut...

*<sigh>* “If it’s not one thing, it’s another.” Thanks to the assistance of folks here, I solved my fuel supply issues on my old LT1046 and last Friday knocked down the thigh-high weds that had grown while it was out of commission. But when I went out this morning to give it a second cut...

I recently scored a used Predator 9kw generator for next to nothing, because apparently it needed a new cylinder head. I replaced that and it runs and generates power just fine . . . but it belches white smoke like mad, and so it almost certainly needs a ring job (or worse). (I suspect it had...

Greetings: I have a fairly old LT1046 that’s been dependable over the years; it could sit for months (with a float charger on the battery), and it usually would start right up. Last year, it started running rough and having some starting issues, which I solved by replacing the carb, filters...

Greetings: I have an old LT1046. Recently started having all sorts of issues, which I ultimately traced to a disintegrated gasket in the gas cap, which led to water in the gas and all the issues resulting from that. Gas cap (Cub Cadet 751-3124B) itself is fine, it just needs a fresh gasket...

I have a TroyBuilt power washer powered by a 4.5 B&S engine that uses the 795469 carb (the kind that has a priming bulb and mounts directly to the gas tank, which has a mounting plate with machined channels that forms the bottom of the carb). I recently have had all manner of problems getting...

Greetings: I have a Troy Bilt pressure washer that has a B&S 4.5 HP vertical shaft engine (appears to be 10J902 or close to it). Recently, the engine developed the following problem: it’ll start and run a few seconds on the gas from priming it with the bulb, but won’t run at all thereafter...