Search results

Results 1 to 7 of 7
  1. G

    Kohler Command Blowing the fuse and kill wire

    2003 17hp CV490S-27508 Engine starts and runs fantastic. All original. Engine in a Craftsman LT2000. With kill wire connected at coil and new fuse, engine will start and run but will blow the fuse every time. Disconnect kill wire at coil engine starts and runs great too, fuse does not blow...
  2. G

    Timing mark on Honda GXV120

    Finally found it, crank gear timing mark on GXV120 off of a HR214 mower. It was impossible for me to see without magnification on a clear pic. It's at the very base of the tooth.
  3. G

    Paint on deck

    OK What paint is everyone using on their decks that is able to resist gasoline?
  4. G

    Where does Honda spring 16593-ZM0-000 go?

    This came off of a Husq mower with Honda GCV160 manual choke engine. I can't seem to figure out where this spring goes on the control arm of the choke mechanism.
  5. G

    Briggs 450e hard to start

    Briggs 450e runs well when I get it started. Complaint is it is very hard to start (20 pulls) when dead cold after priming, even if I spray starting fluid in carb. When warm it can still take a few pulls (7 or8). When it does fire up it starts very very slow RPM sputter, and then takes a few...
  6. G

    What is causing this clicking?? Video link

    Briggs 190cc flathead watch the throttle. What is up with the governor?
  7. G

    Little help with Carb rebuild kit please

    Hi, I have Troy Bilt Pony 42inch mower with B&S engine: Model 31C707 Type 0603 B2 Code 080812ZD What is the proper Nikki carburetor rebuild kit? Thank you, 6strings and a bottle!
Back
Top