Search results

Hi all, Ten years ago I inherited a Scag Tiger Cub that had previously been rode hard. Over the last 3-5 years I've been having some drive control problems. The right wheel seems to pulsate and sometimes wont move, then just takes off rapidly. With both arms all the way forward the mower will...

MN: 407677 0258 E1 The last time the mower ran great and the next time I started it, the mower ran bad like it was starving for fuel. I pulled the float bowl and found one of the two jets from the pickup tube in the bottom of the bowl along with the O-ring that seals between the float bowl...

Hi, I've got an old Scag STC48V-19KA1, SN:6700070. I'm trying to level the cutter deck, but the adjustment bolt is walking on me. I am unable to find a parts breakdown for this particular SN to know if there is some sort of small flat adapter piece that goes on the end of the round bolt to...

I just checked/replaced idler pulleys and belts and think I overlooked having a wrong idler pulley. I started it up and noticed a burning rubber smell without engaging the blades. Looking closer, even though the diagram shows the idler pulleys being the same, shouldn't one pulley be flat and...

Hi, I read about valve adjustment to be done cold, on the compression stroke, TDC, 1/4" past TDC, etc so I finally just rotated the engine until there was the greatest gap. I tried to set the gap at .005"-.006", but I'm guessing that's not where they ended up. The engine turns over like it has...

I have what looks like a cover on the lower left side of the engine. I was wondering if that cover can simply be unscrewed and replace with an oil filter? M/N 4076770 258E1 Thank you in advance!

Hi, I just installed a new idler pulley and replaced the spindles recently. After installing the cutting belt and rotating the pulley, I noticed the belt rides high on idler pulley. Is this ok or should I try to shim the pulley up higher? Also, how tight should the cutting belt tension be...

Hi, I managed to make it 64 years without hooking up a battery backwards, but that streak ended recently when I was in a hurry ☹️ Once I connected my jump start battery correctly, I was able to get the mower started, but it sputtered and stopped a few seconds later. M/N: Mower: 13AQ617H118...

Hi, I managed to make it 64 years without hooking up a battery backwards, but that streak ended recently when I was in a hurry ☹️ Once I connected my jump start battery correctly, I was able to get the mower started, but it sputtered and stopped a few seconds later. M/N: Mower: 13AQ617H118...