Search results

no spark when engine shut off after running for 1 hour just turning backwards and making a loud bangging noise like something is going to come side of engine

needs to run for a while over an hour at least

mine makes a knocking sound

changed out the ignition switch did not solve the problem. could a clogged crankcase breather cause the engine to build up pressure since it is not allowing excessive to vent off, thus when you turn the engine off the pressure is vented off via the pistons and causing combustion in the...

model 331877-1371-b1 will send pix of plug later, trying to run when key turned off

i run my briggs engine for an hour and when i shut engine off the engine will diesel (try to run backwards). engine starts up fine runs great. camshaft was replaced 3 months ago. what could be cause and the fix thanks

problem solve: purchased the correct aftermarket switch installed no more blown fuses thank all of you for the help

not oem switch

937854 with kaw engine

can not confirm switch but pins match up and when you turn the key to start position

have a hustler raptor that the owner had the ignition switch went bad, owner replaced but unit would not start. i found bad fuse, replaced tried to start blew fuse. have done a check of conductivity of wires found nothing, i know that i have ground just trying to find a real pain, i have...

turned the coil over and it worked thanks for all the help great site ac service shack

used it on other engines works fine

new tester tried that and nothing and rope speed is good

oem honda parts

did remove small wire still no spark even with new coil nothing, replaced kill switch under fly wheel, checked to see if ground wire was bad and it was good no shorts, using a spark checking tool that connects to spark plug and coil has a light in middle to see if there is any spark, magnets...

i have a honda gcv 160 i can not get any spark replaced coil, spark plug and ground wire and still no spark any clues thanks AC

seat switch was overridden thanks for the drawing will do checks on monday will keep you informed

I have a poulan pro p54z (zero turn) that i replaced the motor starts great but when i take the brake off it dies. i have replaced all of the safety devices and pto switch and there is not change still dies when brake is taken off. looking for any help and electrical drawing for this mower to...

have a b/s 24 hp model 44s877-0040-g1 , compression 50 psi on one cylinder 60 psi on other one. replaced one coil have both cylinders firing. engine will start run for a little amount of time, but will start right back up, acts like it runs out of gas fuel pump good, solenoid bad but stays open...