Search results

Ferris FD731V Kawasaki -Only one coil fires. It may be a dead short problem. I tested the old coil and it tested good with a volt meter. I replaced it with a new OEM coil that also tested good. When installed they test 0 ohms. When I pull the kill wire off there is still no spark. I must...

61" Ferris IS3000Z Water Cooled FD731V Kawasaki 25hp. This motor only starts on full choke and highest rpms. The PTO also only works when engaged with the highest rpms. This problem just started. When I engage the PTO the motor dies. If I quickly shut off the PTO and engage it again it...

This is a PTO on a Ferris IS3000Z with a Kawasaki FD731V engine. I thought the pulley was supposed to be free wheeling, it sounds raspy when I turn it. Is that normal? The bearing seems to be tight.

This is a 22" Toro 20333 rear wheel drive personal pace recycler. The BBC belt broke. When I took it apart I found this mangled part that looks like it was a flat washer. I don't see anything like it in the parts diagram. The diagram shows a different part (#20 in the diagram). I ordered the...

What is the torque on the bolts that go into the tapered bushing on the spindle on an IS3000Z? I've snapped one off before and don't want a repeat. I'm having repeated problems with the driver's side (furthest left when seated facing forward) spindle. This is the second time the keyway wallowed...

Why would the Carb solenoid wire only draw 6.5 volts? Shouldn't it be 12 Volts? Motor runs when I spray starter fluid in the carb, then dies. If I jump the solenoid with 12 volts, it runs. What should I be looking at?

I'm installing a John Deere Proprietary Kawasaki FD731V-HS02 Liquid Cooled motor into a Ferris IS3000Z I'm having a problem matching the motor harness to the frame harness. The Kawasaki FD731V was stock for John Deere X540 or X520 mowers. The wiring schematics I see are only parts diagrams...

Where does the yellow wire from the motor harness go to. It has the round end with a hole. It looks like it might go to the solenoid, but could be a ground. Does anyone have the wiring schematic for this mower? Thanks for helping me out.

I have a self propelled Cub Cadet mower Model CC46ES that starts right up, runs a few seconds, then it dies. Here are the numbers: Mower Model 12AE46JA009 Mower Serial Number 1F071K30583 Engine Serial Number 2P70M0C1010102A0314 Here's what I have done Changed out the gas New Carb New Fuel Lines...

Replaced Ignition, Seat Switch Brake Switch, Time Delay Module, Fuses I can jump the hot wire on the starter to the ground and the starter turns over. But when I turn the key, nothing happens. No sound, no click. I am behind on a job and need this fixed yesterday. Please help if you can.

It looks like a key, but it doesn't look like it goes through the shaft. How do I remove the key and get the pulley off to replace the spindle? Is there a video anyone knows of. Thanks in advance for your help. I have jobs waiting on this fix.

I checked fuses and battery terminals. Battery is charged. When I turn the key, I hear a faint click from the starter area. I replaced the starter, ignition switch, both relays, and time delay module. With the switch on the small terminal from the solenoid has no power. Any ideas? I can't...