Search results

I prob bent it accidentally taking the carb off. It's straightened now and is not binding in either the intake or the fuel hose. Messed up something else, though, as moving the throttle lever doesn't move that throttle arm.

I didn't get any single picture in which the whole writing was visible because of the angles/lighting. Putting them together (B&S) I see Model 44N877, Type 0003G1. I attached a picture showing the spring I think you're talking about, which looks to be firmly connected.

Here are the three top views and a lower view. I can't see how the spring I highlighted does any good since the rod is inside it. Maybe it should, because if I manually life that rod while the engine is running it revs down just fine. Moving the throttle lever moves the round plate quite a bit...

I haven't yet found a clear image that would help me find my error. I *thought* I took good pics before taking the old one off, but I must have missed something. Interestingly, if I move the throttle to choke, the bar on the bottom left goes up as I think it should. But when I pull the lever...

Yeah, moving the throttle lever appears to move the throttle arm under the carb through its full range. But maybe I should check it. I think I saw a YouTube video on that... move throttle arm to full, loosen the screw in the bracket, hold throttle arm up fully while retightening the screw?

Thanks... that screw must be in a different spot, maybe underneath. The one on top right didn't do it.

Newbie here, I put a new carb on Husq YTA 24V48. Throttle linkage seems to be fine, and pulling it back to low does slow it a bit, but not nearly as low as it should be. Is this some kind of governor adjustment, or what??