Recent content by Youngwill

Yes. Before the mowing season starts again, I intend to replace those interior connectors with solid wire between the battery and starter button. The quick connectors are not needed. The wires are connected to the battery with spade connections anyway and that is good enough. All of the other...

Well. It appears I lied to you (not intentionally). As i was removing the battery from the "box" that holds it and the starter button, one of the wires practically fell out of the plastic connector between the battery and the button. I was able to put the wire back into the connector and solder...

Temperature is about 45 deg and I did not warm up the engine. However, I did put the battery on the charger for about an hour and when I took it off voltage was about 13 v. I pressed the start button and it was able to turn the engine over, but it did not start. Voltage at the charging port...

OK. I'll give that a try. Right now we are going through a chilly spell. Would it be best to put it on the charger for a while to warm it up. Of course, the engine is going to be cold (btn 30-40 deg probably). I can try to start it with the recoil and let it warm up a bit.

It is an Li-ion battery. No date that I found Yes. All of the connections are clean and tight. Thanks

I have a Husqvarna walk behind selfpropelled mower with electric start. It has the B&S motor and is similar to this one: https://www.walmart.com/ip/Husqvarna-LC221FHE-961480062-3-N-1-Self-Propelled-Gas-Lawn-Mower-Electric-Start-163cc-Engine-21-In/980630017 i bought it used last summer and, in...