woodstover's latest activity
-
For others following this, to use translator by right clicking anywhere in the message field area and a menu will drop down, select... -
Lots of know how on this forum, you'll benefit
-
Dirty carb and or fuel system. Dry rotted fuel lines. Tank cap not venting. Trash in the tank and tank outlet. Possibles that are...
-
re the carb.....you don't "see", you blow out passages with compressed air.
-
Hello blue262, First, are you using the correct spark plug and is it gapped correctly? I prefer to use Champion plugs on the older B&S...
-
woodstover reacted to SeniorCitizen's post in the thread Engine won't crank - Stuck on compression? with
Like.
I hope you know the piston should be @ the top on the compression stroke -
woodstover reacted to Rivets's post in the thread Engine won't crank - Stuck on compression? with Like.
Simple test before throwing time and money at this engine. Before opening the engine hook a VOLT meer across the battery and watch the...
-
woodstover reacted to ILENGINE's post in the thread Engine won't crank - Stuck on compression? with Like.
With the valve gaps set correctly, and the spark plug removed for easier engine turning, turn the engine by hand while watching the...
-
woodstover reacted to slomo's post in the thread Replaced coil but still not getting spark with Like.
Is it installed upside down?
-
woodstover reacted to Auto Doc's's post in the thread Replaced coil but still not getting spark with Like.
Hello JohnnyMtn, You could have gotten a bad coil. "New" does not mean good, especially online. Some coils have been returned many...
-
woodstover reacted to hlw49's post in the thread Replaced coil but still not getting spark with Like.
Did you mount the coil correctly?
-
I finally revisited the mower for a pic to show where I relocated the height adjustment cable's pin and marked the spot with some white...
-
The adjustment rod normally has threads that end, therefore you can’t keep tightening the nut. By putting a spacer, shim, washer...
-
woodstover reacted to BIGBREW's post in the thread Kubota Z421 - Hard to get blades spinning. with Like.
I ran on old Simplicity 61-inch zero turn before this one. That one you could pull the pto at a pretty low rpm. Guess I am just...
-
First thing to check are battery cable connections, both on the battery and solenoid, plus negative chassis ground. Make sure each one...