Recent content by wmg2

Need a diagram to rewire an Ariens GT18 anyone have one they would share?

Looking for a GT18 wiring diagram. Anyone have one available?

I am replacing the engine on my Snapper rear engine rider. The original was an engine without the fuel solenoid on the carb, the ignition switch was a three pole with a hook up for battery, starter and armature. The new engine has a solenoid and I need to know what switch would work and which...

Hi. Need help to post pictures. Have looked through the site but can not find the directions. Need a push.

Looking for a Snapper RER mower repair manual. Need for the series 7 to 11 mowers. If anyone can help will buy or down load.

I recently bought a 14hp V twin Briggs engine that originally came out of a Cub Cadet, model unknown, and I am putting it into my Snapper rear rider, more work than I thought it was going to be but love the challenge. The model# of the Briggs is 294777, type 0035-01. I need to know what the...

Have a Techumseh engine on my snapper RER. had to rebuild the carb because it was putting gas straight through, needle not seating. Now the engine starts but I have no speed control. Wants to rev way too high. I can control the speed if I hold the governor rod manually. Always wants to push to...

Need a wiring diagram for my Snapper RER that has a Tecumseh engine on it. The engine model numbers are 150129H, TVN193.

My neighbor, that I am helping with, has a Cub Cadet series 1000, OHV twin that runs wide open when started. All the linkage and springs seem to be in place. When the throttle is held closed on starting it will idle, but as the throttle shaft is moved it will go to all the way wide open with not...

Helping a neighbor out with his Cub Cadet Series 1000. Here are the numbers off the s/n plate D608G101, 1B070H20453. The engine only runs wide open when started there is no idle control. When the throttle is held closed to control speed and then slowly opened there does not seem to be any...

Need a motor, new, used what ever. 10 - 14hp to get one of my RER Snappers running again

Joined the other day and have already had some very good feed back to questions I have had. Decided to join because I put my hand up at the wrong time and got 7 Snapper RER mowers. One runs and is being used by my wife. The others need some to a lot of work. have 2 sold so far and will have...

Need a wiring diagram for a Snapper rear engine rider with a Tecumseh (model 15019H) engine. Have a wire that is burned off and have no idea where it goes. All I can tell is that it comes from the engine and passes under the carb. Cannot find a wire that it might attach to need help.

I bought an older 28" cut Snapper RER with a Tecumseh engine on it. I have to do some carb work as it lets gas run right through to the engine, getting a kit for it. But I noticed that one of the wires coming from the engine , under the carb is burned, broken do not know. I cannot find a...

Have a 10 HP (model 220707 type 0641-01). Was leaking gas from the carb. Installed a carb kit and that cleaned that up. Now I get an engine surge at all speed ranges, seems like the engine starves for gas for a second. under load with me on the unit and the mower engaged the engines runs good...