Recent content by Tommyboyxd

So have any of you guys been able to strip using your RER? If so how high is your cutting height? Thanks

So I got my RER and after a about a month of mowing with it I'm coming to the conclusion it cuts to low. I cut with the deck all the way up and it is cutting the grass at about 2". I normally cut at 3.5" Is there a way to raise the deck higher? I have been reading on the service manual, and...

I have found the service manual for the 4, 5 and 6 series but I have not been able to locate one for the 3 series. Anyone else know if there is an electronic version out there? Thanks, Tom

I found a replacement engine, it was attached to this 30" RER. I'm going to use the 30" for a while until I have time to swap over the engine to my 25". I am going to swap because the 25" is in better condition even though it is a bit older. I'm trying to figure out the original specs on the...

I am having trouble figuring out this old engine and the specs so I can replace it. Briggs and Stratton Model 252707 Type 0617 01 Code 87031410 Is there a site to look up the horse power, shaft size, mounting bolt pattern and so on?

Hello, new guy here, I'm not sure as to what year snapper I have and that is probably blasphemy here as I have seen some of the awesome restores you guys have done. I have been searching around on the forum but I have yet to find anything on engine internals. I just bought this mover last...