Recent content by tim4

That is what I did but it was going in too hard so a machine shop friend looked at it and he said the screw that was in the new spring I got is too big diameter for the hole so he let me borrow a 6.1 metric tap and it worked fine.

I figured that but the screw was going in too hard and I was afraid of braking it off.

I found out there is a small piece that slides off which has a opening to get to the adjustments. On the replacement cylinder I bought the hole that the vibration spring screw goes in is not tapped. It is a 7.100 metric tap sice. Is that a common size or is it special size.

I got it running but how can I get to the adjustment screws after I put the air cleaner assembly in there is no hole to get to the mixture screws.

I think it will work now sinced I cleaned the fuel pump section again

I have a husqvarna k750 which has new cylinder, piston and rings and new crank seals. It will run if you squirt fuel in the sparkplug hole but it does not seem to suck the fuel up from the tank. The fuel filter is new and fuel is getting to the carb when I take the line of f fuel runs out of the...