Recent content by TheVirginian

So in "Craft2" pic, i took it and edited it in paint and attached it. That's where the fuse is on the MTD type of the Craftsman PYT9000 series. did NOT look like a fuse holder at first and was way overtaped (even though it didn't protect end where fuse was, lol). It looked at first, a LOT...

Ok so starting from battery terminals, pics follow into frame/chassis to solenoid. Red wire leaves solenoid and rejoins main harness. Travels frame under left foot rest and splits below fuel tank and feeds display panel, ignition switch and PTO knob. Other split goes to voltage regulator and...

Ok, where to begin? LOL.......this "Craftsman Professional series" PYT9000 i've had since 2009 when we bought it brand new. Last summer, the left spindle (has 3, 50" cut) seized and sheared off some of it's housing (still bolted to deck but blade flopping). I get three new spindles this...

Ok, so here's the skivvy.......I bought (TRADED for, rather) a WELL used STT61A-27KA Turf Tiger. I traded BRAND NEW hot AND cold power washing equipment ( commercial, 4300psi, 4.0gpm) and was ASSURED the Scag was good to go and ready to rock. I did the test run around his yard and it started...

Hey folks. Dave, in Virginia here. I want to brag on my scag but only time will tell....lol. Traded a 13hp, honda powered 4300psi 4.0GPM pressure washer and a Beckett HoT Water addon box (also 4300psi, 4.0gpm, 30A, diesel fired) and all the accessories I'd purchased with/for them (24'...