Recent content by thehill

Thank-you! I ordered the carb. The connector at the bottom is square so the connector will install either way. How do I know what the polarity should be? Is that a solenoid on the bottom?

Please clarify for the carb what kit number, given it's a Walbro carb with a fuel pump? Is it a 20 521 02-S fuel pump kit?

See added photo of carb body with Walbro

Carb

I added a photo showing the fuel pump. I also added a photo of the carb showing the Walbro stamp. You will notice that I added a shut off valve in fuel line and I close it and burn the gas out. If I Dont close the valve and burn the fuel out it smokes white smoke when it is started again...

The mower was running. It sat for a few weeks. Then, when I tried to start it, it fired for 1/2 a second, then it would not start. Then I noticed gas running out of the air filter / card/ I would appreciate any help you could give. I have not been able to find any info on this carb or a rebuild...

On carbs I use Gas.

I have an old snapper mower with a 12 Hp Briggs engine. Last year it quit and would not crank. I had had no spark so I had checked out the wiring and would up replacing the coil. Got the spark going but stillwouldnt crank. So I put the mower up and just dragged it out this week. I took the...

Wow thank you so much this is really helpful! You are so kind!!

Thanks for the advice, everybody. It Bern helpful in thinking through this. Haven't figured it out yet!

Here is an update. It appears when you put it in forward or reverse the drive belt is not being tensioned. I can use the belt on the oully stvgge transmission to move the mower forward or reverse. I can pull the belt on the front and the front pully wont move even if I try to turn it by hand...

Thanks I'll try to turn it. One other think I noticed, when I depress the brake the lock handle shoots out as the pedal goes down. Don't remember it doing that.

One thing I see that I think is different the when I apply the brake the lock stick for the brake thrust outward towards the back of the mower. I Dont remember it doing that. This is my eldetly unckle’s mower so just not familiar with it!

I was driving forward and the mower just stopped moving forward. There was a small limb that run up under the mower that could have caused the issue? I made sure the pin in back is released. I jacked up the mower. The drive belt is on both pulleys. The wheels spin freely in any position of the...